On Sale Metex MS-9150. We take purchase orders and can provide special school, government and corporate pricing.

Cookies This forum uses cookies. Some cookies may have been set already..If you are logged in please click the red X button on the right to accept our cookies and remove this message. If you continue to use the forum, we will assume you are happy to accept the cookies anyway. If you are not happy to accept the cookies you must stop using the forum and delete our cookies from your browser. (Our use of cookies has not changed, however we are now legally obliged to inform you of their use and gain your consent). Vintage Test Gear and Workshop Equipment For discussions about vintage test gear and workshop equipment such as coil winders. I seem to recall it is a null-modem cable.

Manual metex ms- 9150 service service repair shop User's Guides, Owner's Manuals, Service Manuals, Instructions Books - The largest database. In most sites in the. Metex MS-9150 Vintage Test Gear and Workshop Equipment. UNIVERSAL SYSTEM MS-9150 / MS-9160 FEATURE ALL-IN-ONE UNIVERSAL SYSTEM • 2.7GHz Frequency Counter • 2MHz Function Generator (MS-9150) 10MHz Function Generator(MS.

I have never used Windows, but used to use DOS, 20 years ago. You needed to use a Baud rate that was not too fast for the particular device, and select which com port. Comm1, comm2, comm3 or comm4 were the only choices if I remember correctly, but usually Comm1 or Comm2. It was always easier if you used a propriety package, though the name of the one I used eludes me. In the early days of USB adaptors, they did NOT work with all hardware, and a true serial port was necessary. Hello, Some time ago I became the owner of a Tenma 72-5085.

This appears to be the same device as a Metex MS-9150. The posts here got me started on the RS-232 connection of the device. In the end I got it working so I thought I would share my findings. The port on this device is RS-232, using following settings: Baudrate 1200 Databits 7 Stopbits 2 Parity None Handshake None Protocol: D: return the value measured. Download Blosics 2 Level Pack Hacked Photos on this page. (Commands are executed after sending a linefeed ' n' character) To get the device connected to my PC a breakout box with lights to check the connections turned out to be very useful. Finally a DB25F-DB9M converter and a DB9F-DB9F gender changer made the proper connections for TxD and RxD (These came from my stock, I guess a DB25F to DB9F should work as well). Using this adapter the connection seemed correct, but I did not see a response on my screen yet.

Government Warning Paranoid Mess Rare. Both RxD and TxD lights were showing activity, the TxD light however was only very faint. This is caused by the implementation of the TxD 'transceiver' of the MS-9150. The schematic of a MS-9150 shows that only TxD and RxD are connected, and that opto-couplers are used for isolation. The implementation of TxD only uses a pull-down between signal ground and the TxD pin using the transistor of the opto-coupler and a 3.3k resistor. This might have worked on old-fashion implementations of a serial port, but in my case it did not.

I am using a USB-to-UART converter which did not include a pull-down on RxD to pull the input to idle level when nothing was connected. In my case adding a resistor of 10k between the negative output of the charge-pump of the level shifter of the USB-to_UART converter, and the RxD pin fixed this. The levels used are far from standard-compliant, but the USB-to-UART converter accepts it. With the pull-down resistor communication is working and I can read the measured values on my PC. According to the schematic the RS-232 port is only connected to the multimeter part of the device. Garo Special Byakuya No Majuaruana there.